张家口升降平台

1、升降机厂家http://www.jnsjht.cn/介绍升降机运行期间，检修运行人员要经常检查泵站、电机各部位有无异音，经常检查泵在运行状态下的震动情况，保证泵的平稳运行。
Lift manufacturers introduced during lift operation, maintenance personnel should always check the pump station is running, there is no different from all parts of the motor sound, always check the pump in the running state of shock cases, to ensure the smooth operation of the pump.

2、升降机厂家建议运行人员要定期检查轴承的润滑状态，油量油位是否正常，甩油环随泵转动是否灵活，随时能够保证轴承得到充分润滑。
Lift manufacturer recommends operating personnel to regularly check the bearing lubrication, fuel oil level is normal, slinger with the pump rotation is flexible, ready to be fully able to guarantee bearing lubrication.

3、升降机厂家提醒油路是否正常，轴承温度是否在规定温度下，还要注意电流、压力是否正常，轴承温度是否在规定温度下，还要注意电流、压力是否正常，保证升降机各部位紧固螺丝有无松动现象，观察承载箱体有无漏油、进水现象。
Lift manufacturers remind the oil is normal, bearing temperature is at a predetermined temperature, but also pay attention to current, pressure is normal, bearing temperature is at a predetermined temperature, but also pay attention to current, pressure is normal, to ensure that all parts of the fastening screws have lift no loosening, observe whether the bearing box oil spills, water phenomenon.

4、升降机厂家http://www.jnsjht.cn/介绍平时泵站运行方式采用两用一备方式进行切换运行，备运泵在停运后运行人员应立即关闭泵的出入口门，然后再关闭备用泵的轴封水门，保证泵的腔体内始终存在清水，以防灰水进入泵腔体内沉积造成泵体叶轮和付叶轮被积灰堵塞而造成下次启动烧马达故障。
Manufacturers usually lift pump station operation mode introduces a standby mode using dual switch operation for shipment after the outage run pump should immediately turn off the pump entrance door, and then close the door spare pump seal water, to ensure the pump cavity there is always water, gray water into the body to prevent the dePOSTTTION chamber causing the pump impeller and pump impeller is plug fouling pay next time you start to burn and cause motor failure.

济南亘安信息提供技术支持：http://www.jngenan.com/