台达PLC DVP10PM00M
台达PLC DVP10PM00M

产品资料：

Connectors for 8 ,7 ,6 , 4 , and 3 mm diameter Cables (i.e., Cables

that are 7 to 8, 6 to 7, 5 to 6, 4 to 5, and 3 to 4 mm in diameter

respectively) are available. When assembling a Connector used

with a cable, make sure that the external diameter of the Connector

is suited to that of the cable.

? A watertight bushing for 6/7 mm diameter Cable has no stripe, that

for 8/4 mm diameter Cable has a single stripe, and that for 3 mm

diameter Cable has two stripes.

(2) Component Insertion

? As shown in the above illustration, connect the above components

to the Cable with its end processed.

(3) Wiring (Processing Cable Ends)

? Strip 10 mm of the Cable sheath and 4 mm of each core.

? Before soldering cores and solder cup pins together, solder-coat

each of them.

? The following conditions are recommended for soldering each

solder cup pin.

Soldering temperature: 350±5°C

Soldering period: 3±1 s

? The length marked *A should be 6.5 mm max., otherwise the

proper degree of protection of the connector will not be maintained.

? Strip 14 mm of the Cable sheath and 4 mm of each core.

? Make sure that each core is not damaged and its end strands are

not spread out.

? Mount the XY2F-0003 Locator to XY2F-0002 Crimping Tool, both

of which are sold separately, and set the selector dial of the

Crimping Tool to 8.

? After mounting the crimping pins to the Locator, fully insert the

cores to the crimping pins.

? Squeeze the handle of the Crimp Tool to press-fit the cores to the

crimping pins.

(Squeeze the handle firmly until the handle automatically returns to

the release POSTTTION.)

? After press-fitting the cores to the pins, insert the pins into the pin

clamp as shown in the illustration. Then make sure that the lead

colors correspond to the pin clamp numbers that are identical to

the connector pin numbers.

Crimping/Soldering Connectors

Screw-on Connectors

Cover

Watertight

bushing Cable

clamp Cap

Cover