大剪升降机用动力单元_卡车尾板_扬州瑞杰企业贸易有限公司

简介General  DeSCRJPTion
此液压动力单元采用零泄漏双向止回阀实现两条油路的完全隔离，使用两条油路的上升和下降动作互不干涉，是多缸单独升降系统的理想动力源。该系列动力单元广泛用于子母台式（大剪）升降机，采用直流电机可用于卡车尾板
Equipped  with  the  zero  leakage  bi-directional  solenold  valves,this  power  unitfulfils  the  complete  separation  of  the  two  independent  circuits,which  are  respectively  for  the  main  platform  and  subordinate  platform  of  the  double  scissors  lift.By  increasing  the  number  of  the  solenoid  vavles,it  is  easy  to  get  more  independent  circuits,which  are  used  to  control  the  corresponding  cylinders.

说明：
1.如需不同流量的泵、压力、电机功率等系统参数，请查看液压动力单元型号说明。
1.Please  go  to  page  1  or  consult  our  sales  engineer  for  the  different  pump  displacement,motor  power  or  tank  capacity.
2.如需手动应急放油装置，请在订货时说明。
2.The  manual  override  function  is  available  on  request.
注意事项Special  Notes
1.此动力单元不可连续运转，（1分钟ON，9分钟OFF）可重复工作。
1.The  power  unit  is  of  S3  duty,which  can  only  be  worked  intermittentiy,ie.,1  minute  on  and  9  minutes  off.
2.安装前必须保证油缸、油管、接头等液压元件清洁无任何杂质粘附。
2.Clean  all  the  hydraulic  parts  concemed  before  mounting  the  power  unit.
3.液压油粘度应为15-68CST，应清洁无杂质，推荐使用N46号液压油。
3.The  viscosity  of  the  oil  shoud  be  15-68  cst.
4.系统使用第一个100小时后，应更换液压油，以后每3000小时更换一次液压油。
4.Change  the  oil  after  the  first  100  hours  of  using  the  power  unit,then  change  the  oil  every  3000  hours.
5.本液压动力单元适用于立式安装。
5.This  power  unit  should  be  mounted  vertically.
6.首次启动运行系统时，应立即检查油箱中的油量是否充足。
6.Check  the  oil  level  in  the  tank  after  the  first  star  of  the  power  unit.

大剪升降机用动力单元

详细说明

产品说明Explain

公司简介Content

卖家名片Cards

卖家名片

扬州瑞杰企业贸易有限公司

该供应商的其他产品

你可能感兴趣