1、填料压得太紧或四周紧密度不够2、填料压得偏斜与轴磨损严重
1.The PADCING is
pressed too tight or the around compactness is not enough
2.The PADCING is
pressed deflected and the axile wears seriously
1、旋松压盖螺栓高速填料紧密度
2、松开压盖重新均匀地上紧
1.Loosen the gland bolts to adjust
2.Loosen the gland bolts and tighten it again.
898995850
