2017/6/1 18:31:11 来源： 新乡市中隧机电设备有限公司
二次搅拌机技术规格：
1：容量：180-200L-400-600-800-1000L（可选)
2：电机功率：3KW
3：转速：54r/min
4：搅拌量：6m3/h
5：重量：200kg
6：装料高度：980mm
7：外形尺寸：直径*高度：800*1146mm 1000*1200
配合使用泵类产品
河北省邯郸市砂浆搅拌机 搅拌机，是一种带有叶片的轴在圆筒或槽中旋转，将多种原料进行搅拌混合，使 之成为一种混合物或适宜稠度的机器。 搅拌机分为好多种，有强制式搅拌机、 单卧轴搅拌机、双卧轴搅拌机等等。注意事项：搅拌机及自动供料机，必须把里 面清洗干净，尤其是冬天，这样能延长寿命。搅拌机即是混合机，因为混合机的 通常作用就是混合搅拌各类干粉砂浆，故俗称搅拌机。 本机属于自落式双锥反转出料移动式混凝土搅拌机，可搅拌塑性和半干硬性混凝 土。搅拌筒正转搅拌，反转出料，每罐可搅拌350升混凝土(指捣实后混凝土体积 )，每小时可生产10~14立方米。适用于一般建筑工地、道路、桥梁工程和中小型 混凝土构件厂。固定搅拌时，可挖地坑，使料斗口与地面平齐，进料方便，大大 减轻劳动强度。 本机结构新颖，具有生产效率高，搅拌质量好、重量轻、造型美观等优点，是一 种比较先进的机型。河北省邯郸市砂浆搅拌机
With the tunnel section is the radial distribution, the longitudinal 100cm and transverse 80cm in the plum blossoms. The construction process of hollow grouting anchor rod is as follows: construction preparation, drilling hole, hole cleaning, installation of anchor rod and grouting. The measurement line, calibration of anchor, and marked on the rock face. The use of drilling jumbo drilling, drilling, strictly control the direction and angle of radiation. The drilling is completed, check whether the eye straight smooth, not qualified to drilling, checked by high-pressure wind hole, through on-site supervision engineer after inspection, the bolt into the hole. The installed sleeve, stop grouting plug, plate and nut, after installation, injection of cement mortar. When grouting should be discharged in gas holes, to ensure the full grouting and grouting quality, grouting pressure control between 0.5 ~ 1Mpa, after grouting, the drawing instrument timely applied not less than 60KN prestressed. It adopts bolt tension meter for bolt tensile test of the final, tensile strength is not less than the design requirements of 150KN. It can make the construction site records including bolt length, grouting pressure, grouting quantity, time, tension resistance etc..
898995850
