绵阳代理日本富士电机GYS101D5-RA2
绵阳代理日本富士电机GYS101D5-RA2

产品资料：

100 Ω max. in LOCAIIONs subject to

excessive noise.台达伺服电机  三菱伺服电机 西门子电机

(4) to (6): Output terminals

(7), (10): Power supply terminals for S3D2-AKD/-CKD/-CCD西门子电机

 Sensors (+24 V), and other models (+12 V)

(9), (12): Power supply terminals for the Sensor (0 V)

(8), (11): Output terminals for the Sensor

Connect the Sensor output lines

Nomenclature

* Be sure to set the one-shot timer.

No. Name Functions

(1) POWER indicator (green)台达伺服电机  三菱伺服电机 西门子电机

Lights when the operating power is turned ON and the Sensor power supply is output.

Not lit when the operating power is turned OFF, or the Sensor power supply is short circuited

(between the +12-V or +24-V terminal and 0-V terminal).

(2) IN1 indicator (red) Lights when the output from the Sensor connected to IN1 is received by IN1 as an input.

(3) IN2 indicator (red) Lights when the output from the Sensor connected to IN2 is received by IN2 as an input.

(4) OUT indicator (red) Lights when the output turns ON.台达伺服电机  三菱伺服电机 西门子电机

(5) IN1 input signal selector switch NORM: Input as a signal when the Sensor’s output transistor (or contact output) is ON.

(6) IN2 input signal selector switch INV: Input as a signal when the Sensor’s output transistor (or contact output) is OFF.

(7) MODE

(AND/OR operation selector switch)台达伺服电机  三菱伺服电机 西门子电机

AND: The output is turned ON when IN1 and IN2 input signals are both ON.

OR: The output is turned ON when either IN1 or IN2 input signal is ON.

(8)

SYNC

 (synchronous mode selector

switch)台达伺服电机  三菱伺服电机 西门子电机

(This switch is enabled only when

the AND/OR operation selector is

set to AND.)

: The output is turned ON while both IN1 and IN2 input signals are ON.

: If the input signal of IN2 is turned ON (at the rising edge) while the IN1 input signal is ON, the

output is turned ON.*台达伺服电机  三菱伺服电机 西门子电机

(9) TIMER switch台达伺服电机  三菱伺服电机 西门子电机

Turns timer operation ON/OFF.

ON: Timer enabled台达伺服电机  三菱伺服电机 西门子电机

OFF: Timer disabled