三菱变频器FR-D720S-0.75K-CHT
三菱变频器FR-D720S-0.75K-CHT

产品资料：

Ring (Angled models only) *

Watertight

bushing

Cable clamp Cap

Straight Connectors

Angled Connectors

* A ring is not required for Screw-on Connectors.

Cover

Cover西门子变频器 欧姆龙变频器 台达变频器

Watertight bushing

Watertight

bushing

Cable clamp

Cable clamp

Cap

Cap

Ring *1

(*2 )

Confirm that you have all of the required parts.西门子变频器 欧姆龙变频器 台达变频器

Insulation caps and insulation tubes are included with

five-pole Connectors (XS2C-D5S@ and XS2G-D5S@).

*1. Rings are not required with 7-mm and 8-mm cables.

*2. Insert the waterproof bushing for 7-mm and 8-mm

cables in the direction shown in the diagram.

? Tentatively insert the pins to the pin block holes so that the key on

the pin block will coincide with the key groove on the pin clamp.

Then insert the cable along with the pin clamp.

? Loosen the screws on pins 1 to 4 and insert the cores according to

the pin numbers.

? Use the dedicated Screwdriver (XW4Z-00B)* and tighten the

screws securely so that the cores do not pull out (tightening torque:

0.15 to 0.2 N·m).

? Five-pole Connectors

? Strip the cable sheath for a total of 15 mm and strip the core

covering for 8 mm for the core to connect to pin 5.西门子变频器 欧姆龙变频器 台达变频器

? Connect the core to pin 5 (in the center) first.

? Insert the core from the side of the hold with the tab and tighten the

screw securely (tightening torque: Pins1 to 4: 0.15 to 0.2 N·m,

Pins5: 0.03 to 0.05 N·m), and then cut off the excess wire with wire

cutters.

? Bend the cable as shown below, attached the enclosed insulation

cap, and then strip the other cores.

? Connect the cores to pins 1 to 4.西门子变频器 欧姆龙变频器 台达变频器

Connecting Shielded Cables to Five-pole Connectors

西门子变频器 欧姆龙变频器 台达变频器西门子变频器 欧姆龙变频器 台达变频器西门子变频器 欧姆龙变频器 台达变频器